Usually with a refinish job sanding is awfully time consuming especially on raised panel doors.
Sanding a six panel door.
This free video diy guide provides some much need help.
Use a sanding sponge above on inside corners where fingers can t reach.
Door sanding can be difficult.
Start with a light sandpaper or a sanding sponge 180 or 220 grit.
While some of you will have them unmounted and laying down making it easier i bet that most of you want to do it with the doors still mounted which is much more.
Use a short thin screwdriver and a hammer to drive the pins out.
It s so easy in fact that this clip can present a complete overview of the process in just over two and a half minutes time.
Happily refinishing a door is easier than you might think.
No need to bust out the power sander you can use a sanding block or sheet of sand paper.
Lightly sand the entire door.
This is usually the most time consuming tedious part of the project.
Apply one to two coats of penetrating stain wiping off any excess.
Use a hand figuring out how to go about refinishing a pine door.
Wipe off the door with a damp rag to remove any sawdust.
Always sand with the grain of the wood.
Remove the hinges deadbolt door knob and any other hardware.
Sand the door again with 150 grit followed by 220 grit sandpaper.
Remove the hinge pins out of the hinges on the interior side of the door.
The main goal is to give your door a little tooth for the new paint or primer to adhere to.
I first strip using goudey paint or lacquer then scrape it off wash with diluent and sand.
Be sure to sand down any bumps or blemishes.
Fold a half sheet of 100 grit sandpaper in thirds press it into a section of the profile with your fingertips then rub back and forth in long strokes over the length of the molding.
Even if the door hasn t previously been painted treated or sanded it s also good to sand it down to open up the fibers and help it accept the stain more easily.
Sand the door smooth.
Chris and i have painted a lot of six panel doors in our time we installed and painted 8 new doors at our first house and every door in our current house is a primed and unpainted six panel door in need of paint.
For more and better information take a look.
Smooth out chipped paint and imperfections from previous paint jobs.
Avoid sanding inside if possible.
Use an orbital finish sander or sanding pad with 220 grit sandpaper to sand the door quickly and remove minor imperfections.
Sand the door down to bare wood with 100 grit sandpaper.
Lay the door across the.
This will roughen the surface a little and allow the primer to adhere better.
From panel ornaments to windows and other intricate details that get in the way of an easy sanding job you need the right tools to ensure your success.
If there s some dye stain left in the wood i use chlorine bleach which is good for removing dye stains without affecting the natural color of the wood.
